Watch a video of this BCM at the bottom of this page.

New Genuine GM Body Control Module for 1999-2000 GMC Denali or Cadillac Escalade.  BCM Modules control a number of electrical features from interior lighting all the way down to radios and door chimes. This is a brand new GM unit and is not rebuilt.

Free Programming!  It will be programmed when it arrives at your door!

We are The BCM  Experts! Over 165,000 Satisfied BCM Module Customer Since 2006!

Fits any 1999-2000 Denali Or Escalade

Do you have a 1999-2000 Denali or Escalade? Do you have annoying electrical problems that are driving you crazy?

The original BCM Modules installed in these Trucks were just poor quality and disintegrate internally after a few years.

Our Solution

We are selling a Genuine GM  completely revised  module that Will never fail again  The new BCM is completely redesigned internally by GM engineers to never fail again.

• Free Programming!  No paying the dealer for programming!  This Module comes to you pre-programmed at no additional charge.  Compare to your local GM dealer who charges an average of 2 hours of labor or approximately $150.00 for programming or other online sellers who make you buy their BCM and then take it to a dealer to be programmed.
• includes 100% Brand new Circuitry and case
• Includes the newest GM Software Updates.
• Comes sealed in Genuine GM Packaging. 
• Factory Fresh Direct From GM
• Includes one year replacement Warranty

Be careful!

Many companies and dealers are still selling the old design because it is cheaper and they can make more profit. If you get the old design you will just have the same problem again. We only sell the new design BCM. 

The picture shown is a sample photo only, yours may look different

Return policy:  

We have a Very Strict No Refund policy On BCM Modules.

Unfortunately since these modules are commonly bought as test parts to diagnose a problem on a vehicle, we are unable to accept a return of any BCM module for a refund for any reason. Just think about it this way, nobody wants to buy a returned module that somebody else used to test their vehicle, Anything could have happened to it during that time, including shorting it out, getting it wet, breaking connector pins etc. You do not want to buy somebody's problem and we do not want to sell you one.

We want to remain as open and honest with our customers as possible therefore we have instituted this policy. Once you purchase the BCM module  it cannot be returned even if you have never opened the box, please know that the module is yours to keep once purchased. 

The Module does however have a 1 year warranty, and if found to be defective within 1 year, we will swap the module out for a new for you during this time. 

Keyless remote programming 

You will need to programm your keyless remotes to the vehicle using the simple instructions below:

Have each of the transmitters that you intend to program ready. This vehicle will allow you to program a maximum of four transmitters programmed at one time.

When reprogramming the remote control door lock receiver, All transmitters must be programmed at this time in order for the transmitters to operate the vehicle. Transmitters not programed at this time will not work and the procedure will have to be redone with all the transmitters.

Turn the ignition to the RUN position, then back to the OFF position. This will disarm the theft-deterrent system.

Remove the RADIO fuse (Fuse 17).

Turn the ignition from the OFF position to the RUN position three times quickly, within five seconds . The vehicle will respond by locking the doors, unlocking the driver's doors and releasing the tailgate or panel doors. The transmitter is now ready to match to the vehicle.

Press and hold the LOCK (1) and UNLOCK (2) buttons on the first transmitter for 15 seconds . The vehicle will respond as in step 3.

Repeat step 4 for the remaining transmitters.

Replace the RADIO fuse.

Check that all transmitters work by pressing their buttons.