Note This will only fit Camry Built In the USA. The first digit of your VIN number will be a 4 if built in the USA.
If you have a J as the first digit of the VIN (Japan Built). This Visor will not fit You can find the correct visor HERE
Fits any 2007-2011 USA built Camry Including Hybrids.
Your VIN number is required. There are 48 Different color, style, and size combinations to this visor. Please put your 17 digit VIN number in the box when adding the visor to your cart. Leaving the VIN number Field blank or typing anything else in the field will only delay your order. The VIN allows us to send you the exact visor for your Car, and there is no chance for mistakes.
The Original Problem
Do you have a 2007-2011 Toyota Camry? Is the visor falling down and obstructing your vision?
The original sun visors installed in these cars had a major problem. The visor will not stay up and it constantly falls while driving or running over a bump. Its not just your car, every Toyota Camry manufactured in these years has the same problem. The support rod loses tension over time, and begins to lose grip.
We are selling a completely revised Genuine Toyota Visor that will not fall down, and will not lose tension. The new visor is completely redesigned internally by Toyota engineers to never fail again. This is the 4th and Final revision of this visor, and has excellent reliability compared to the last 3 versions.
Be wary of sites selling the old versions for a low price, you will have the same issue with the visor falling within a few months of purchase.
When you make your selections in the drop down menu, you will receive the exact configuration that is in your car now, pertaining to color, lights, Fabric etc..
installs easily with a flat blade and a Phillips screwdriver
matches your interior fabric color exactly.
Comes sealed in Genuine Toyota Packaging.
Factory Fresh Direct From Toyota
1. Disengage the 4 claws from the sunvisor plastic
2. Remove the plastic bracket cover and set aside for later installation.
3. Carefully pull straight down on the Sunvisor
sub-assembly and remove it from the opening in
the metal roof panel.
If the attaching clips remain in the metal roof
panel, pinch the clip tabs together and rotate
away from the connector as shown in Figure 3
(if equipped with a vanity light), then remove
the clips and reinstall the clips back into the
sunvisor bracket from the direction shown in
1. Partially install the bracket cover into the sunvisor
bracket making sure both temporary set claws are
Make sure to ONLY partially install the bracket
cover into the bracket during installation,
because damage to the clip, sunvisor mount or
roof sheet metal tabs may occur if the bracket
cover is fully in the sunvisor bracket.
2. Install the sunvisor assembly into the opening
in the sheet metal roof panel by grasping the
sunvisor assembly with two hands and pushing
the bracket upward
3. Make sure the sunvisor bracket is ﬂush with the
headliner all away around the perimeter of the
bracket as shown in Figure 7 and then push the
bracket cover upward to engage all 4 claws at the
4. Conﬁrm the proper operation of the sunvisor and the operation of the vanity light.